6.5. Analysis of Efficiency by Speed

Here we have analysed the speed of the loom against the efficiency. Speed of loom plays an important role in efficiency as well as productivity.

So an almost care is necessary for the analysis of the speed of the looms and their influence on the field.

Table 6.10 Speed Vs Efficiency

This has been a normal chart. Whenever there is higher loom speed it leads to higher end breakages. This will reduce the efficiency. But when you run a loom at lower speed then the productivity decreases. Higher production also plays an important role in the industries improvement. So it is recommended to run the looms at optimum speed.

6.6 Analysis of Improved Efficiency

We have given ideas from the studies taken to improve the efficiency of the industry. The chart below will show the improved efficiency

Table 6.11 Sort Vs Improved Efficiency

From the analysis which have taken, and by viewing the charts from the beginning of this chapter it evident that we can improve the efficiency of the looms. Lots of measures have been taken and the fig 4.7 shows the increase in the efficiency.

First we have advised for the supervisor for the industry, who should be there for all eight hours of the shift. It will considerably increase the efficiency. It is also very useful if rotating cameras are fixed all around the loom shed so that the efficiency will increase.

The next is the loom allocation, in sort three mainly three weavers are allocated and in sort one, four weavers are allocated. We can interchange these allocations. Because sort three is a difficult design and it is where more stoppages occur.

The weavers room atmosphere plays an important role in loom efficiency. The relative humidity and the temperature should be maintained properly and constantly to get a maximum efficiency. Whenever there is a change in these two parameters then there will be a change or drop in the efficiency.