 |
|
| Page 1 | Page 2 | Page 3 |
Product Page:
|
Sinvex Plastic Sleeves:
Plastic sleeves are extremely hard and therefore mark resistant and are based on poly amide resins. These are used for calendering and one sided embossing, for linear loads upto 350 kg/cm and metal roll temperatures upto 210ºC with working speed upto 200m/min.
|
|
Friction Free Plastic Bushings
Most Hot, Wet & Chemical applications limit the use of hard bearings where one good possibility is to use our Mekton Teflon 53 bushes suitable for temp. resistance upto 2500C & absolute chemical resistance in corrosive baths along with very low coefficient of friction (0.1 - 0.2) with excellent wear resistance (recommended only for low speeds). |
For further information log on to : www.sirtres.it |
Teflon Heat Shrinkable Sleeves:
For heat, chemical, antistick and adhesive applications in textiles, paper, coating, lamination and plastic films etc. |
|
| |
Avalable Sizes
Shrinkable sleeves are available in standard range
- Nominal Ø from25 mm 662 mm with wall thikness 0.5 mm.
- Length from 0.9 to 6.1 mts.
- Longer length are available on request (up to 10 mts.).
- Starting from Ø 5", wall thickness 0.75 - 1 - 1.5 - 2.3 mm.
Teflon shrinkable sleeves are available in two different materials : the choice depends from the working temperature and from the mechanical stress of the application.
- Teflon FEP upto 160 degree Celsius
- Teflon FEP HT upto 220 degree Celsius max. and / or for mechanical high stresses.
Available Types
Furthermore, incase of high mechanical stress or temperature, sleeves must be bonded on roll surface; in this case the inside diameter will be “etched” (bondable).
Installation:
We believe the correct fitting operation has to be considered the main point for a long lifetime and successful service of the shrinkable TEFLON sleeves.
This is the reason why we do prefer to make the installation work.
|
| |
| Page 1 | Page 2 | Page 3 |
